zomorod full plastic paint
Zomorod opaque full plastic coating paint The paint is made of vinyl acetate copolymer emulsion matte alloys. This paint is used for all surfaces (gypsum, cement, concrete, brick, woodcut and wooden) inside the building. Excellent resistance to rinsing, excellent exfoliation, rapid drying, proper pencil, water dilution, excellent adhesion, ease of use, unpleasant odor and environmental […]
Zomorod opaque full plastic coating paint
The paint is made of vinyl acetate copolymer emulsion matte alloys. This paint is used for all surfaces (gypsum, cement, concrete, brick, woodcut and wooden) inside the building. Excellent resistance to rinsing, excellent exfoliation, rapid drying, proper pencil, water dilution, excellent adhesion, ease of use, unpleasant odor and environmental compatibility are among the benefits of this paint.
| Theoretical coverage | ۱۲٫۵-۱۴٫۵ square meters per liter (for dry film thickness 30μ)
۹٫۵- ۷٫۵ m 2 / liter (50 μm dry film thickness |
| Surface drying time | Maximum 1 hour |
| Time to apply the next layer | At least 3 hours |
| Glossy | Opaque |
| Ignition point | |
| * The drying time depends on the air flow, ambient temperature, humidity, thickness and number of layers. |
| Surface preparation | Before painting, prepare the surface by separating the loose points, opening the gaps and joints, separating the layered colors. Then, if necessary, plaster or putty, smooth the surface of the substrate and then sandpaper. The final surface before painting should be clean and free of any contamination, dust or grease. |
| Method of Use | ۱٫ Pour all the emulsion matte plastic with the proper amount of water and apply it on the surface. The degree of mixing of water with paints is different according to the ambient temperature, surface area and coloring agent, but under normal conditions of staining, this amount is 35% to 25% with a roller of 10% – 5% and with a 40% dispersion of 35 % is.
۲٫ To achieve a uniformly colored surface, at least 2 to 3 paint application steps may be required under the surface. ۳٫ Application of paints at an ambient temperature of 10 ° C, surface temperature of 3 degrees above dew point and humidity of less than 80% is recommended. |
| Wash the tools | After work, wash hands, stapler or dusted materials on the ground with warm water and soap. To prevent rust, rinse tools and equipment with a White Spray solvent and dry immediately |
| Safety notes and storage conditions | Refer to medical centers if swallowed or in contact with the eyes (after washing with plenty of water). Keep container contents in a cool, dry place, away from direct sunlight and with adequate ventilation. Avoid frosting the paint. After taking the lid, close the container firmly. The best use time is when stored in suitable storage conditions up to 36 months after the date of production. |
